VR Tuned ECU Flash Tune McLaren 570S | 570 GT | 570 Spyder

Tuning the ECU of your McLaren 570S is possible with VR Tuned. Our tuning tools allow us to access the data on the Bosch ECU to give you a tremendous gain of 100ft/lbs of torque at 4500rpm and nearly 80whp as tested on our Project Vehicle. With the ECU tune, the driving characteristics are vastly improved while providing you additional benefits that your engine craves for. Through all modes, the tuning helps improve the vehicles performance while not affecting daily driving characteristics. As tested on our Mustang AWD Dyno here in Arizona, we typically see a 20% drivetrain loss. From these calculations, this is 449awhp from the stock 562bhp. Our dyno test reveals 479awhp which would be about a 15% drivetrain loss. The tune peak power is at 519awhp. With the same drivetrain loss calculated, this is just over 600hp to the crank. For those looking to improve their McLaren 570 off and on the track, this is ECU Flash for you!Crank Horsepower Ratings:

• Stock Power: 562HP | 442FT/LBs
• Tuned Power: 620HP | 502FT/LBs

What are the benefits of VR Tuned?

• #1 priority is our customer service to you!
• Our tuning is used worldwide. We have powered vehicles of all types.
• All ECU tunes can be reverted back to stock if necessary.
• With the VR Tuned ECU Flash, basic bolt-on performance parts will not require a retune of your ECU.
• Adding parts such as an exhaust, intake, plenum, pulley, will all adjust with the tune.
• If you add higher octane fuel, the ECU will adjust accordingly.
• We can tune cars worldwide including JDM, EU, Australian, and USA cars for different types of octane or environments.
• Other custom enhancements are available if requested and applicable.
• We test and dyno tune on our own cars to make sure what you get is safe, reliable, and gives you the results you want!

How to Flash Your ECU?

• We can bench flash the ECU. To bench flash the ECU, you must remove it from your vehicle and send it to us. Once we receive the ECU, we will prepare the tune file and then ship it back to you for re-installation. We do not solder or modify the ECU board at all. All ECU tuning is done via bungy probes that have a needle tip to provide an electrical connection. ECU Removal Instructions Here

For reference, this ECU is a BOSCH ME17.8.32.